Chair has threaded mounting hole for 5/8″ docking bolt from factory. This part is a Drivers Kit, which is comprised of the docking bolt, advanced stabilizer, and stabilizer hardware to be used with the QLK-150.

Chair discontinued by manufacturer.

Please verify all measurements (See “Wheelchair Measurement Guide” at top). Standard Tubing is 7/8″ and Frame Rail -6″

Wheelchair has less than 2″ of Ground Clearance

Also know as Vision Select and Vision Super.  This Kit features our QLK-150 Advanced Stabilizer.

Note: Bolt is installed under the actuator in the center of the chair. Front or rear entry is more recommended as locking into the system and turning may not be possible.

Note: Bolt is installed under the actuator in the center of the chair. Front or rear entry is more recommended as locking into the system and turning may not be possible.

Note: Bolt is installed under the actuator in the center of the chair. Front or rear entry is more recommended as locking into the system and turning may not be possible.

Low Ground Clearance.

Wheelchair has less than 2″ of Ground Clearance